2007-2013 Highlander Kluger · Service Manual COMMUNICATION SYSTEM

Television Camera ECU Communication Stop Mode

Circuit diagnosis · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010

DESCRIPTION

Detection Item
Symptom
Trouble Area
Television Camera ECU Communication Stop Mode
Parking assist monitor is not displayed on "BUS CHECK" screen of intelligent tester
  1. Power source or inside television camera ECU
  2. Television camera ECU branch wire and connector
  3. Television camera ECU

WIRING DIAGRAM

C170467E01

INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistances of CAN bus main wires and CAN bus branch wires.
  2. After the ignition switch is turned off, check that the key reminder warning system and light reminder warning system are not operating.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches, or the doors. If any doors need to be opened in order to check the connectors, open the doors and leave them open.

HINT:
  1. Operating the ignition switch, any other switches, or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
  2. Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below will help determine the cause of the malfunction.


1. CHECK CAN BUS LINE FOR DISCONNECTION (TELEVISION CAMERA ECU BRANCH WIRE)

  1. C170445E01
    Disconnect the television camera ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    N15-7 (CANH) - N15-6 (CANL)
    Ignition switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO NETWORK GATEWAY ECU (CANH, CANL)
OK


2. CHECK WIRE HARNESS (TELEVISION CAMERA ECU - BATTERY AND BODY GROUND)

  1. E149946E04
    Disconnect the television camera ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    N16-8 (GND1) - Body ground
    Ignition switch off
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    N16-1 (+B) - Body ground
    Always
    10 to 14 V
    N16-4 (ACC) - Body ground
    Ignition switch on (ACC)
    10 to 14 V
    N16-3 (IG) - Body ground
    Ignition switch on (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE PARKING ASSIST ECU (TELEVISION CAMERA ECU) (Click here)


← Center Airbag Sensor Communication Stop Mode (from Jul 2010)Television Camera ECU Communication Stop Mode (Aug 2008 – Jun 2010) →