2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Multi-media Interface ECU Communication Error

Circuit diagnosis · Vehicles built from Jul 2010

INSPECTION PROCEDURE


1. IDENTIFY COMPONENT SHOWN BY SUB-CODE

  1. Enter diagnostic mode.E110917E23

  1. Press preset switch "2" to change to "Detailed Information Mode".

  1. Identify the component shown by the sub-code.

    HINT:
    1. The sub-code "P190" shown in the above example indicates.
    2. For details of the DTC display, refer to DTC Check/Clear (Click here).


NEXT


2. CHECK POWER SOURCE CIRCUIT OF COMPONENT SHOWN BY SUB-CODE
  1. Inspect the power source circuit of the component shown by the sub-code.If the power source circuit is operating normally, proceed to the next step.

    Component Table 
    Component
    Proceed to
    Radio receiver (190)
    Radio receiver power source circuit (Click here)


NEXT


3. INSPECT RADIO RECEIVER

  1. E200688E20
    Disconnect the radio receiver connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E24-9 (TXM+) - E24-10 (TXM-)
    Always
    60 to 80 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Radio Receiver)



NG
REPLACE RADIO RECEIVER (Click here)
OK


4. CHECK HARNESS AND CONNECTOR

HINT:
  1. Start the check from the circuit that is near the component shown by the sub-code first.
  2. For details of the connectors, refer to Terminals of ECU (Click here).

  1. Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the multi-media interface ECU and component shown by the sub-code.

    1. Disconnect all connectors between the multi-media interface ECU and component shown by the sub-code.

    2. Check for an open or short in the AVC-LAN circuit between the multi-media interface ECU and component shown by the sub-code.

      OK:
      There is no open or short circuit.

      E162966E13



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5. REPLACE COMPONENT SHOWN BY SUB-CODE
  1. Replace the component shown by the sub-code with a known good one and check if the same problem occurs again.

    OK:
    Malfunction disappears.



NG
REPLACE MULTI-MEDIA INTERFACE ECU (Click here)
OK

END


← Radio Receiver Communication Error (from Jul 2010)Radio Receiver Power Source Circuit (May 2007 – Jul 2008) →