2007-2013 Highlander Kluger · Service Manual SECURITIES

Ignition Switch Circuit

Circuit diagnosis · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

The main body ECU determines the ignition switch position (OFF, ACC, ON) based on signals from the IG or ACC circuit.

WIRING DIAGRAM

B154254E03

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to the ON position.

  1. Turn the intelligent tester main switch on.

  1. Select the items below in the Data List and read the display on the intelligent tester.

    Main Body: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    IG SW
    Ignition switch ON signal / ON or OFF
    ON: Ignition switch is in the ON position
    OFF: Ignition switch is OFF
    -
    ACC SW
    Ignition switch ACC signal / ON or OFF
    ON: Ignition switch is in the ACC position
    OFF: Ignition switch is OFF
    -

    OK:
    When the ignition switch is operated, the display changes as shown in the table.



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. CHECK HARNESS AND CONNECTOR (BATTERY - INSTRUMENT PANEL JUNCTION BLOCK)

  1. B154257E02
    Disconnect the 1A junction block connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    1A-1 - Body ground
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT IGNITION SWITCH ASSEMBLY

  1. B125076E04
    Disconnect the D21 ignition switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 4
    Ignition switch ON
    Below 1 Ω
    2 - 4
    Ignition switch ACC
    Below 1 Ω



NG
REPLACE IGNITION SWITCH ASSEMBLY (Click here)
OK


4. CHECK HARNESS AND CONNECTOR

  1. B154258E02
    Disconnect the 1I junction block connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1I-4 - 1I-9
    Ignition switch ON
    Below 1 Ω
    1I-4 - 1I-3
    Ignition switch ACC
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5. CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL JUNCTION BLOCK - BODY GROUND)

  1. B164981E02
    Disconnect the 1F junction block connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    1F-10 - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)


← Ignition Switch Circuit (May 2007 – Jul 2008)Ignition Switch Circuit (from Jul 2010) →