Ignition Switch Circuit
Circuit diagnosis · Vehicles built from Jul 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
The main body ECU determines the ignition switch position (OFF, ACC, ON) based on signals from the IG or ACC circuit.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER |
 |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn the intelligent tester main switch on.
Select the items below in the Data List and read the display on the intelligent tester.
Main Body:
Tester Display
|
Measurement Item/Range
|
Normal Condition
|
Diagnostic Note
|
IG SW
|
Ignition switch ON signal / ON or OFF
|
ON: Ignition switch is in the ON position OFF: Ignition switch is OFF
|
-
|
ACC SW
|
Ignition switch ACC signal / ON or OFF
|
ON: Ignition switch is in the ACC position OFF: Ignition switch is OFF
|
-
|
- OK:
- When the ignition switch is operated, the display changes as shown in the table.
|
NG |
 |
|
|
|
| OK |
|
 |
|
| PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
|
|
| 2. CHECK HARNESS AND CONNECTOR (BATTERY - INSTRUMENT PANEL JUNCTION BLOCK) |
 |
- Disconnect the 1A junction block connector.
Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
|
Condition
|
Specified Condition
|
1A-1 - Body ground
|
Ignition switch ON
|
11 to 14 V
|
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
 |
|
| 3. INSPECT IGNITION SWITCH ASSEMBLY |
 |
- Disconnect the D21 ignition switch connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
|
Condition
|
Specified Condition
|
1 - 4
|
Ignition switch ON
|
Below 1 Ω
|
2 - 4
|
Ignition switch ACC
|
Below 1 Ω
|
|
NG |
 |
|
|
|
| OK |
|
 |
|
| 4. CHECK HARNESS AND CONNECTOR |
 |
- Disconnect the 1I junction block connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
|
Condition
|
Specified Condition
|
1I-4 - 1I-9
|
Ignition switch ON
|
Below 1 Ω
|
1I-4 - 1I-3
|
Ignition switch ACC
|
Below 1 Ω
|
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
 |
|
| 5. CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL JUNCTION BLOCK - BODY GROUND) |
 |
- Disconnect the 1F junction block connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
|
Specified Condition
|
1F-10 - Body ground
|
Below 1 Ω
|
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
 |
|
| REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK) |
|