2007-2013 Highlander Kluger · Service Manual HEATER & AIR CONDITIONING SYSTEM

DISASSEMBLY

Removal / installation · Vehicles built from May 2007


1. REMOVE DRAIN COOLER HOSE

  1. E149740
    Remove the drain cooler hose.


2. REMOVE REAR AIR MIX CONTROL SERVO MOTOR SUB-ASSEMBLY

  1. E149742
    Disconnect the connector.

  1. Remove the 2 screws and rear air mix control servo motor sub-assembly.


3. REMOVE REAR AIR OUTLET CONTROL SERVO MOTOR SUB-ASSEMBLY

  1. E150091
    Disconnect the connector.

  1. Remove the 2 screws and rear air outlet control servo motor sub-assembly.


4. REMOVE REAR AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY

  1. E150090
    Remove the packing.

  1. E150093E01
    Remove the screw <C>.

  1. Remove the screw <B>.

  1. Remove the bolt <A>.

  1. E150095
    Remove the bolt and slide the hook connector.

  1. Remove the rear air conditioning tube and accessory assembly.

  1. E150096
    Remove the 2 O-rings from the rear air conditioning tube and accessory assembly.


5. REMOVE HEATER WATER PIPE AND HOSE SUB-ASSEMBLY
  1. Using pliers, grip the claws of the 2 clips and slide the clips to disconnect the heater water hose.

  1. Remove the 2 screws and the heater water pipe and hose sub-assembly.

    E150097


6. REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY

  1. E150098
    Remove the screw and the heater clamp.

  1. E150099
    Remove the heater radiator unit sub-assembly from the rear cooling unit as shown in the illustration.


7. REMOVE REAR BLOWER MOTOR SUB-ASSEMBLY

  1. E150101
    Remove the 3 screws and the rear blower motor sub-assembly.


8. REMOVE BLOWER MOTOR CONTROLLER

  1. E150102
    Remove the 2 screws and the blower motor controller.


9. REMOVE REAR COOLING UNIT EXPANSION VALVE

  1. E150103
    Disengage the 3 claws and remove the plate.

  1. E150104
    Remove the grommet.

  1. E150105
    Using a 4 mm hexagon wrench, remove the 2 hexagon bolts and rear cooling unit expansion valve.


10. REMOVE REAR EVAPORATOR SUB-ASSEMBLY

  1. E150106
    Remove the 12 screws.

  1. E150107
    Remove the rear evaporator sub-assembly as shown in the illustration.

  1. E150109
    Remove the 2 O-rings from the rear evaporator sub-assembly.


11. REMOVE REAR EVAPORATOR TEMPERATURE SENSOR

  1. E150110
    Disengage the clamp.

  1. Disengage the claw and the rear evaporator temperature sensor.

← REMOVAL (from Jul 2010)REASSEMBLY (from May 2007) →