Display Signal Circuit between Television Camera ECU and Navigation Receiver Assembly
Circuit diagnosis · Vehicles built Aug 2008 – Jun 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010
DESCRIPTION
This is the display signal circuit from the television camera ECU to the navigation receiver assembly.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - TELEVISION CAMERA ECU) |
Disconnect navigation receiver assembly connector E21.

Disconnect television camera ECU connector N21.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
E21-1 (GVI+) - N21-1 (GVO+)
Always
Below 1 Ω
E21-2 (GVI-) - N21-2 (GVO-)
Below 1 Ω
E21-3 (GVG1) - N21-3 (GVG1)
Below 1 Ω
E21-1 (GVI+) - Body ground
10 kΩ or higher
E21-2 (GVI-) - Body ground
10 kΩ or higher
E21-3 (GVG1) - Body ground
10 kΩ or higher
|
|
||||
| OK | ||
| ||
