B2251 Back Door Closer Switch Malfunction
Diagnostic trouble codes · Vehicles built May 2007 – Jul 2008
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
The power back door drive unit (power back door ECU) inputs signals from the full-latch switch, sector switch and back door courtesy light switch, which are built into the back door lock. Based on these switch signals, the latch position of the back door lock is determined.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2251 |
While back door closer is operating, malfunction is detected in position information from each switch within specified amount of time |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE ON INTELLIGENT TESTER (BACK DOOR COURTESY LIGHT SWITCH) |
Check the Data List to determine if the back door courtesy light switch function properly.
Back door (Power back door ECU) Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Courtesy SW
Back door courtesy light switch signal / ON or OFF
ON: Back door is open
OFF: Back door is closed
-
- OK:
- The display is as specified in the normal condition.
|
|
||||
| OK | ||
| ||
| 2. INSPECT BACK DOOR LOCK (BACK DOOR COURTESY LIGHT SWITCH) |


Remove the back door lock. (Click here)
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
- Back door courtesy light switch:
Tester Connection
Door lock latch Position
Specified Condition
3 (BDCY) - 4 (GND)
Open-latch
Below 1 Ω
3 (BDCY) - 4 (GND)
Half-latch
Below 1 Ω
3 (BDCY) - 4 (GND)
Full-latch
10 kΩ or higher
3 (BDCY) - 4 (GND)
Over-latch
10 kΩ or higher
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (BACK DOOR LOCK - POWER BACK DOOR ECU AND BODY GROUND) |
Disconnect the T4 door lock connector.

Disconnect the O14 ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
T4-3 (BDCY) - O14-20 (FUL)
Always
Below 1 Ω
T4-4 (GND) - Body ground
Always
Below 1 Ω
T4-3 (BDCY) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
