2007-2013 Highlander Kluger · Service Manual BODY

B2251 Back Door Closer Switch Malfunction

Diagnostic trouble codes · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

The power back door drive unit (power back door ECU) inputs signals from the full-latch switch, sector switch and back door courtesy light switch, which are built into the back door lock. Based on these switch signals, the latch position of the back door lock is determined.
DTC No.
DTC Detection Condition
Trouble Area
B2251
While back door closer is operating, malfunction is detected in position information from each switch within specified amount of time
  1. Back door lock
  2. Wire harness
  3. Power back door drive unit (Power back door ECU)

WIRING DIAGRAM

B165214E05

INSPECTION PROCEDURE


1. READ VALUE ON INTELLIGENT TESTER (BACK DOOR COURTESY LIGHT SWITCH)
  1. Check the Data List to determine if the back door courtesy light switch function properly.

    Back door (Power back door ECU) 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Courtesy SW
    Back door courtesy light switch signal / ON or OFF
    ON: Back door is open
    OFF: Back door is closed
    -

    OK:
    The display is as specified in the normal condition.



NG
Go to step 2
OK

REPLACE POWER BACK DOOR DRIVE UNIT (POWER BACK DOOR ECU) (Click here)

2. INSPECT BACK DOOR LOCK (BACK DOOR COURTESY LIGHT SWITCH)
B143899E10
  1. Remove the back door lock. (Click here)

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Back door courtesy light switch:
    Tester Connection
    Door lock latch Position
    Specified Condition
    3 (BDCY) - 4 (GND)
    Open-latch
    Below 1 Ω
    3 (BDCY) - 4 (GND)
    Half-latch
    Below 1 Ω
    3 (BDCY) - 4 (GND)
    Full-latch
    10 kΩ or higher
    3 (BDCY) - 4 (GND)
    Over-latch
    10 kΩ or higher



NG
REPLACE BACK DOOR LOCK (Click here)
OK


3. CHECK HARNESS AND CONNECTOR (BACK DOOR LOCK - POWER BACK DOOR ECU AND BODY GROUND)

  1. B165204E06
    Disconnect the T4 door lock connector.

  1. Disconnect the O14 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    T4-3 (BDCY) - O14-20 (FUL)
    Always
    Below 1 Ω
    T4-4 (GND) - Body ground
    Always
    Below 1 Ω
    T4-3 (BDCY) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE POWER BACK DOOR DRIVE UNIT (POWER BACK DOOR ECU) (Click here)


← B2251 Back Door Closer Switch Malfunction (Aug 2008 – Jun 2010)Back Door Closer does not Operate (May 2007 – Jul 2008) →