2007-2013 Highlander Kluger · Service Manual HEATER & AIR CONDITIONING SYSTEM

INSPECTION

Inspection · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010


INSPECT COMPRESSOR AND MAGNETIC CLUTCH (A/C LOCK SENSOR)

  1. E167398E35
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    B52-1 (SSR+) - B52-2 (SSR-)
    20°C (68°F)
    160 to 320 Ω

    If the resistance is not as specified, replace the compressor and magnetic clutch.


INSPECT COMPRESSOR AND MAGNETIC CLUTCH (A/C COMPRESSOR SOLENOID)

  1. E116970E95
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    B51-2 (SOL+) - B51-1 (SOL-)
    25°C (77°F)
    10.1 to 11.1 Ω

    If the resistance is not as specified, replace the compressor and magnetic clutch.


INSPECT COMPRESSOR AND MAGNETIC CLUTCH (COMPRESSOR AND MAGNETIC CLUTCH - MAGNETIC CLUTCH)

  1. E167398E36
    Disconnect the connector from the compressor and magnetic clutch.

  1. E167400E15
    Disconnect the connector from the magnetic clutch.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    B52-3 (MG+) - A-1
    Always
    Below 1 Ω
    B52-3 (MG+) - Body Ground
    Always
    10 kΩ or higher

    If the resistance is not as specified, replace the compressor and magnetic clutch.


INSPECT MAGNETIC CLUTCH

  1. E167401E17
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    B-1- Body Ground
    20°C (68°F)
    3.8 to 4.2 Ω

    If the resistance is not as specified, replace the compressor and magnetic clutch.

  1. When connector terminal 1 is connected to the positive (+) battery terminal, check that the following occurs: 1) the magnetic clutch's operating sound can be heard, and 2) the magnetic clutch's hub and rotor lock.

    OK:
    1):
    The magnetic clutch's operating sound can be heard.
    2):
    The magnetic clutch's hub and rotor lock.

    If the result is not as specified, replace the magnetic clutch.

← INSPECTION (May 2007 – Jun 2010)REASSEMBLY (May 2007 – Jun 2010) →