2007-2013 Highlander Kluger · Service Manual HEATER & AIR CONDITIONING SYSTEM

REMOVAL

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start the engine.

  1. Turn the A/C switch on.

  1. Operate the cooler compressor at an engine speed of approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant. This causes most of the compressor oil from the various components of the A/C system to collect in the A/C compressor.

  1. Stop the engine.

  1. Recover the refrigerant from the A/C system using a refrigerant recovery unit.


2. REMOVE V-RIBBED BELT
(Click here)

3. REMOVE RADIATOR ASSEMBLY AND FAN ASSEMBLY WITH MOTOR
(Click here)

4. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY

  1. E212986
    Remove the bolt and disconnect the discharge hose sub-assembly from the compressor and magnetic clutch.

  1. Remove the O-ring from the discharge hose sub-assembly.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.


5. DISCONNECT SUCTION HOSE SUB-ASSEMBLY

  1. E212987
    Remove the bolt and disconnect the suction hose sub-assembly from the compressor and magnetic clutch.

  1. Remove the O-ring from the suction hose sub-assembly.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.


6. REMOVE COMPRESSOR AND MAGNETIC CLUTCH

  1. E212988
    Disengage the clamp.

  1. Disconnect each connector.

  1. E212989E01
    Disengage each clamp.
    Text in Illustration 
    *A
    w/o Oil cooler
    *B
    w/ Oil cooler

  1. Disconnect each connector.

  1. E179377
    Remove the 4 bolts, bracket and the compressor and magnetic clutch.

← REMOVAL (Aug 2008 – Jun 2010)DISASSEMBLY (May 2007 – Jun 2010) →