B1500 Fuel Sender Open Detected
Diagnostic trouble codes · Vehicles built from Jul 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
This DTC is output when the combination meter assembly detects a fuel sender gauge malfunction via the direct line.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B1500 |
When either of the following conditions is detected:
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER (FUEL INPUT) |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the tester on.
Enter following menus: Body / Combination Meter / Data List.
Check the values by referring to the table below.
Combination Meter: Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Fuel Input
Fuel input signal/Min.: 0, Max.: 127.5
Fuel gauge indicates (E): 7.5 (L)
Fuel gauge indicates (1/2): 35.0 (L)
Fuel gauge indicates (F): 62.9 (L)
-
- Result:
Result
Proceed to
Fuel level data can be displayed on the intelligent tester and DTC B1500 is output.
A
Fuel level data cannot be displayed on the intelligent tester.
B
|
|
||||
| A | ||
| ||
| 2. INSPECT COMBINATION METER ASSEMBLY |
Disconnect the E1 connector.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
E1-19 (FE) - E1-34 (FR)
Always
13.5 to 414.5 Ω
|
|
||||
| OK | ||
| ||
| 3. CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - FUEL SENDER GAUGE ASSEMBLY) |
![]() ![]() |
Disconnect the fuel sender gauge assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
E1-34 (FR) - 2
Always
Below 1 Ω
E1-34 (FE) - Body ground
Always
10 kΩ or higher
E1-19 (FE) - 1
Always
Below 1 Ω
E1-19 (FE) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 4. INSPECT FUEL SENDER GAUGE ASSEMBLY |
![]() ![]() |
Remove the fuel sender gauge assembly (Click here).
Check that the float moves smoothly between E and F.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
1 - 2
Float level is F (upper)
3.0 to 5.0 Ω
1 - 2
Float level is between F (upper) and E (lower)
3.0 to 111.0 Ω (Gradually changes)
1 - 2
Float level is E (lower)
109.0 to 111.0 Ω
|
|
||||
| OK | ||
| ||


