2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Sound Signal Circuit between Radio Receiver and Multi-media Interface ECU

Circuit diagnosis · Vehicles built from Jul 2010

DESCRIPTION

The multi-media interface ECU sends the sound signal to the radio receiver through this circuit.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the radio receiver or speakers.

WIRING DIAGRAM

E213358E03

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - MULTI-MEDIA INTERFACE ECU)
  1. Disconnect the radio receiver and multi-media interface ECU connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E25-1 (USD1) - E24-1 (CSLD)
    Always
    Below 1 Ω
    E25-2 (URO+) - E24-2 (CDR+)
    Always
    Below 1 Ω
    E25-3 (URO-) - E24-3 (CDR-)
    Always
    Below 1 Ω
    E25-4 (ULO+) - E24-4 (CDL+)
    Always
    Below 1 Ω
    E25-5 (ULO-) - E24-5 (CDL-)
    Always
    Below 1 Ω
    E25-1 (USD1) - Body ground
    Always
    10 kΩ or higher
    E25-2 (URO+) - Body ground
    Always
    10 kΩ or higher
    E25-3 (URO-) - Body ground
    Always
    10 kΩ or higher
    E25-4 (ULO+) - Body ground
    Always
    10 kΩ or higher
    E25-5 (ULO-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Speaker Circuit (from Jul 2010)Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter (from Jul 2010) →