2007-2013 Highlander Kluger · Service Manual BRAKE

INSTALLATION

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010

NOTICE:
  1. Because the left and right hoses are not interchangeable, verify the part number when installing the flexible hoses.
  2. If the hoses are to be reused, connect them after checking the identification marks placed when each hose was disconnected.


1. INSTALL FRONT FLEXIBLE HOSE

  1. C165870
    Connect the front flexible hose to the disc brake cylinder assembly with a new union bolt and a new gasket.

    Torque:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }

  1. C165382
    Install the front flexible hose with a new clip.

    NOTICE:
    Install the clip as far as it will go.

  1. C165381E01
    Using a union nut wrench (10 mm), connect the brake line to the front flexible hose while holding the front flexible hose with a wrench.

    Torque:
    without union nut wrench:
    15 N*m{ 155 kgf*cm , 11 ft.*lbf }
    with union nut wrench:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }

    NOTICE:
    1. Do not bend or damage the brake line.
    2. Do not allow any foreign matter such as dirt and dust to enter the brake line.
    3. Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).
    4. This torque value is effective when the union nut wrench is parallel to the torque wrench.

  1. C165383
    Install the front flexible hose to the absorber bracket with the bolt.

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }


2. BLEED BRAKE SYSTEM
(Click here)

3. INSTALL FRONT WHEEL

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }

← INSTALLATION (May 2007 – Jun 2010)COMPONENTS (May 2007 – Jun 2010) →