2007-2013 Highlander Kluger · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built from May 2007

NOTICE:
If both the RH side hose and LH side hose are disconnected at the same time, be sure to place identification marks indicating the position on each side.

HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.


1. DRAIN BRAKE FLUID

2. REMOVE REAR WHEEL

3. REMOVE REAR FLEXIBLE HOSE

  1. C167068
    Remove the union bolt and gasket, and separate the rear flexible hose.

  1. C165384E01
    Using a union nut wrench (10 mm), disconnect the brake line while holding the rear flexible hose with a wrench.

    NOTICE:
    1. Do not bend or damage the brake line.
    2. Do not allow any foreign matter such as dirt and dust to enter the brake line.

  1. Remove the clip.

  1. C167191E01
    Remove the bolt and rear flexible hose from the absorber bracket.

← COMPONENTS (from Jul 2010)INSTALLATION (May 2007 – Jun 2010) →