2007-2013 Highlander Kluger · Service Manual COMMUNICATION SYSTEM

B1273 Sliding Roof ECU Communication Stop

Diagnostic trouble codes · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

This DTC is output when LIN communication between the sliding roof ECU (sliding roof drive gear sub-assembly) and main body ECU (instrument panel junction block assembly) stops for more than 10 seconds.
DTC No.
DTC Detection Condition
Trouble Area
B1273
No communication between sliding roof drive gear and main body ECU for more than 10 seconds
  1. Sliding roof ECU (Sliding roof drive gear sub-assembly)
  2. Main body ECU (Instrument panel junction block assembly)
  3. Wire harness

WIRING DIAGRAM

B176995E05

INSPECTION PROCEDURE

NOTICE:
When using the intelligent tester with the ignition switch off to troubleshoot:
Connect the intelligent tester to the vehicle, and turn the courtesy switch on and off at 1.5-second intervals until communication between the tester and vehicle begins.


1. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - SLIDING ROOF ECU)

  1. B172349E02
    Disconnect the D8 connector.

  1. Disconnect the Q12 connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D8-10 (LIN2) - Q12-4 (MPX1)
    Always
    Below 1 Ω
    Q12-4 (MPX1) - Body ground
    Always
    10 kΩ or higher

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D8-10 (LIN2) - Body ground
    Always
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY)

  1. B164448E02
    Disconnect the Q12 connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    Q12-2 (E) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    Q12-1 (B) - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. REPLACE SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY)
  1. Replace the sliding roof ECU (sliding roof drive gear sub-assembly) with a normally-functioning or a new one (Click here).

  1. Clear the DTC.


NEXT


4. CHECK FOR DTC
  1. Recheck for DTC.

    Result:
    Result
    Proceed to
    B1273 is not output
    A
    B1273 is output
    B



B
REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)
A

END


← DIAGNOSTIC TROUBLE CODE CHART (from Jul 2010)B1273 Sliding Roof ECU Communication Stop (Aug 2008 – Jun 2010) →