B1273 Sliding Roof ECU Communication Stop
Diagnostic trouble codes · Vehicles built from Jul 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
This DTC is output when LIN communication between the sliding roof ECU (sliding roof drive gear sub-assembly) and main body ECU (instrument panel junction block assembly) stops for more than 10 seconds.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B1273 |
No communication between sliding roof drive gear and main body ECU for more than 10 seconds |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When using the intelligent tester with the ignition switch off to troubleshoot:
- Connect the intelligent tester to the vehicle, and turn the courtesy switch on and off at 1.5-second intervals until communication between the tester and vehicle begins.
| 1. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - SLIDING ROOF ECU) |
Disconnect the D8 connector.

Disconnect the Q12 connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
D8-10 (LIN2) - Q12-4 (MPX1)
Always
Below 1 Ω
Q12-4 (MPX1) - Body ground
Always
10 kΩ or higher
Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
Condition
Specified Condition
D8-10 (LIN2) - Body ground
Always
Below 1 V
|
|
||||
| OK | |
| 2. CHECK SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY) |
Disconnect the Q12 connector.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
Q12-2 (E) - Body ground
Always
Below 1 Ω
Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
Condition
Specified Condition
Q12-1 (B) - Body ground
Always
11 to 14 V
|
|
||||
| OK | |
| 3. REPLACE SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY) |
Replace the sliding roof ECU (sliding roof drive gear sub-assembly) with a normally-functioning or a new one (Click here).
Clear the DTC.
| NEXT | |
| 4. CHECK FOR DTC |
Recheck for DTC.
- Result:
Result
Proceed to
B1273 is not output
A
B1273 is output
B
|
|
||||
| A | ||
| ||
