2007-2013 Highlander Kluger · Service Manual COMMUNICATION SYSTEM

DTC CHECK / CLEAR

Troubleshooting · Vehicles built from May 2007

NOTICE:
  1. When using the intelligent tester with the ignition switch off to troubleshoot: Connect the intelligent tester to the vehicle, and turn a courtesy light switch on and off at 1.5-second intervals until communication between the tester and vehicle begins.
  2. Refer to the intelligent tester operator's manual for further details.


CHECK DTC
  1. Turn the ignition switch off.

  2. Connect the intelligent tester to the DLC3.

  3. Turn the ignition switch on (IG) and turn the tester ON.

  4. Select the fllowing menus: Diagnosis / Body / Main Body / DTC.


CLEAR DTC
  1. Turn the ignition switch off.

  2. Connect the intelligent tester to the DLC3.

  3. Turn the ignition on (IG) and turn the tester ON.

  4. Select the fllowing menus: Diagnosis / Body / Main Body / DTC / Clear.

← TERMINALS OF ECU (from May 2007)DATA LIST / ACTIVE TEST (from May 2007) →