B2287 LIN Communication Master Malfunction
Diagnostic trouble codes · Vehicles built from May 2007
DESCRIPTION
This DTC is output when there is an open, short or ECU communication malfunction between the main body ECU (instrument panel junction block assembly) and certification ECU (smart key ECU assembly).| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2287 |
There is an open, short or ECU communication malfunction between main body ECU (instrument panel junction block assembly) and certification ECU (smart key ECU assembly). |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When using the intelligent tester with the ignition switch off to troubleshoot:
- Connect the intelligent tester to the vehicle, and turn the courtesy switch on and off at 1.5-second intervals until communication between the tester and vehicle begins.
| 1. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - MAIN BODY ECU) |
Disconnect the D36 and 1E connectors.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
D36-10 (LIN) - 1E-7 (LIN1)
Always
Below 1 Ω
D36-10 (LIN) - 7 (LIN1) - Body ground
Always
10 kΩ or higher
Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
Condition
Specified Condition
D36-10 (LIN) - Body ground
Always
Below 1 V
|
|
||||
| OK | |
| 2. REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK) |
Replace the main body ECU (instrument panel junction block assembly) with a normally-functioning or a new one.
Clear the DTC.
| NEXT | |
| 3. CHECK FOR DTC |
Recheck for DTC.
- Result:
Result
Proceed to
B2287 is not output
A
B2287 is output
B
|
|
||||
| A | ||
| ||
