2007-2013 Highlander Kluger · Service Manual COMMUNICATION SYSTEM

B2789 No Response from ID BOX

Diagnostic trouble codes · Vehicles built from May 2007

DESCRIPTION

This DTC is output when LIN communication between the certification ECU (smart key ECU assembly) and ID code box (immobiliser code ECU) stops for more than 10 seconds.
DTC No.
DTC Detection Condition
Trouble Area
B2789
No communication between certification ECU (smart key ECU assembly) and ID code box (immobiliser code ECU) for more than 10 seconds
  1. ID code box (Immobiliser code ECU)
  2. Certification ECU (Smart key ECU assembly)
  3. Wire harness

WIRING DIAGRAM

B156210E16

INSPECTION PROCEDURE

NOTICE:
When using the intelligent tester with the ignition switch off to troubleshoot:
Connect the intelligent tester to the vehicle, and turn the courtesy switch on and off at 1.5-second intervals until communication between the tester and vehicle begins.


1. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - ID CODE BOX)

  1. B162909E02
    Disconnect the D36 and D28 connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D36-10 (LIN) - D28-3 (LIN1)
    Always
    Below 1 Ω
    D36-10 (LIN) - Body ground
    Always
    10 kΩ or higher

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D36-10 (LIN) - Body ground
    Always
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK ID CODE BOX (IMMOBILISER CODE ECU)

  1. B164449E05
    Disconnect the D28 connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D28-8 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D28-1 (+B) - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. REPLACE ID CODE BOX (IMMOBILISER CODE ECU)
  1. Replace the ID code box (immobiliser code ECU) with a new one.

  1. Delete the DTC.


NEXT


4. CHECK FOR DTC
  1. Recheck for DTC.

    Result:
    Result
    Proceed to
    B2789 is not output
    A
    B2789 is output
    B



B
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
A

END


← B2786 No Response from Steering Lock ECU (from Jul 2010)PRECAUTION (May 2007 – Jul 2008) →