2007-2013 Highlander Kluger · Service Manual COMMUNICATION SYSTEM

B2786 No Response from Steering Lock ECU

Diagnostic trouble codes · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

This DTC is output when LIN communication between the certification ECU (smart key ECU assembly) and steering lock ECU (steering lock actuator assembly) stops for more than 10 seconds.
DTC No.
DTC Detection Condition
Trouble Area
B2786
No communication between steering lock ECU (steering lock actuator assembly) and certification ECU (smart key ECU assembly) for more than 10 seconds
  1. Steering lock ECU (Steering lock actuator assembly)
  2. Certification ECU (Smart key ECU assembly)
  3. Wire harness

WIRING DIAGRAM

B156210E15

INSPECTION PROCEDURE

NOTICE:
When using the intelligent tester with the ignition switch off to troubleshoot:
Connect the intelligent tester to the vehicle, and turn the courtesy switch on and off at 1.5-second intervals until communication between the tester and vehicle begins.


1. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - STEERING LOCK ECU)

  1. B164470E02
    Disconnect the D36 connector.

  1. Disconnect the D10 connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D36-10 (LIN) - D10-5 (LIN)
    Always
    Below 1 Ω
    D36-10 (LIN) - Body ground
    Always
    10 kΩ or higher

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D36-10 (LIN) - Body ground
    Always
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK STEERING LOCK ECU (STEERING LOCK ACTUATOR ASSEMBLY)

  1. B176977E02
    Disconnect the D10 connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D10-1 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D10-7 (B) - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. REPLACE STEERING LOCK ECU (STEERING LOCK ACTUATOR ASSEMBLY)
  1. Replace the steering lock ECU (steering lock actuator assembly) with a normally-functioning or a new one (Click here).

  1. Delete the DTC.


NEXT


4. CHECK FOR DTC
  1. Recheck for DTC.

    Result:
    Result
    Proceed to
    B2786 is not output
    A
    B2786 is output
    B



B
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
A

END


← B2786 No Response from Steering Lock ECU (Aug 2008 – Jun 2010)B2789 No Response from ID BOX (from May 2007) →