2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from May 2007


INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY (for LHD)

  1. E144461E10
    Check the LO operation.

    1. Connect the battery's positive (+) lead to terminal 5 (+1) and the negative (-) lead to terminal 4 (E), and check that the motor operates at low speed (LO).

      OK:
      Motor operates at low speed (LO).

  1. Check the HI operation.

    1. Connect the battery's positive (+) lead to terminal 3 (+2) and the negative (-) lead to terminal 4 (E), and check that the motor operates at high speed (HI).

      OK:
      Motor operates at high speed (HI).

  1. Check the automatic stop operation.

    1. Put the matchmark on the windshield wiper motor assembly.

    2. Connect the battery's positive (+) lead to terminal 5 (+1) and the negative (-) lead to terminal 4 (E). With the motor rotating at low speed (LO), disconnect terminal 5 (+1) to stop the wiper motor operation at any position other than the matchmark.

    3. Using SST, connect terminals 1 (+S) and 5 (+1). Then connect the battery's positive (+) lead to terminal 2 (B) and the negative (-) lead to terminal 4 (E) to restart the motor operation at low speed (LO).

      SST
      09843-18040  

    4. E147815E03
      Check that the motor stops automatically at the matchmark.

      OK:
      Motor stops automatically at the matchmark.

      If the result is not as specified, replace the motor assembly.


INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY (for RHD)

E144461E11
  1. Check the LO operation.

    1. Connect the battery's positive (+) lead to terminal 1 (+1) and the negative (-) lead to terminal 5 (E), and check that the motor operates at low speed (LO).

      OK:
      Motor operates at low speed (LO).

  1. Check the HI operation.

    1. Connect the battery's positive (+) lead to terminal 4 (+2) and the negative (-) lead to terminal 5 (E), and check that the motor operates at high speed (HI).

      OK:
      Motor operates at high speed (HI).

  1. Check the automatic stop operation.

    1. Put the matchmark on the windshield wiper motor assembly.

    2. Connect the battery's positive (+) lead to terminal 1 (+1) and the negative (-) lead to terminal 5 (E). With the motor rotating at low speed (LO), disconnect terminal 1 (+1) to stop the wiper motor operation at any position other than the matchmark.

    3. Using SST, connect terminals 3 (+S) and 1 (+1). Then connect the battery's positive (+) lead to terminal 2 (B) and the negative (-) lead to terminal 5 (E) to restart the motor operation at low speed (LO).

      SST
      09843-18040  

    4. E147814E02
      Check that the motor stops automatically at the matchmark.

      OK:
      Motor stops automatically at the matchmark.

      If the result is not as specified, replace the motor assembly.

← REMOVAL (from May 2007)INSTALLATION (from May 2007) →