2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from May 2007


INSPECT WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY
  1. Remove the washer jar.

  1. Disconnect the windshield washer motor and pump connector.

    HINT:
    The check should be performed with the windshield washer motor and pump installed on the washer jar.

  1. Fill the washer jar with washer fluid.

  1. E144508E01
    Connect the battery's positive (+) lead to terminal 1 of the windshield washer motor and pump, and negative (-) lead to terminal 2.

  1. Check that washer fluid flows from the washer jar.

    OK:
    Washer fluid flows from the washer jar.

    If the result is not as specified, replace the washer motor and pump assembly.

← REMOVAL (from Jul 2010)INSTALLATION (May 2007 – Jul 2008) →