Disconnect the hood lock control cable assembly and remove the lower instrument panel finish panel sub-assembly.
8.
REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY (for LHD)
Remove the 4 bolts.
Disengage the 2 hooks.
Pull out the driver side knee airbag assembly from the vehicle and support the driver side knee airbag assembly with one hand as shown in the illustration.
NOTICE:
When removing the driver side knee airbag assembly, do not pull the airbag wire harness.
Using a screwdriver with the tip wrapped with protective tape, disconnect the driver side knee airbag connector.
NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.
Disengage the 2 claws and separate the DLC3 from the driver side knee airbag assembly.