P0500 Vehicle Speed Sensor "A"
Diagnostic trouble codes · Vehicles built May 2007 – Jul 2008
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
The wheel speed sensor monitors the wheel rotation speed and sends a signal to the skid control ECU. The skid control ECU converts the wheel speed signal into a 4-pulse signal and transmits it to the ECM via the combination meter. The ECM determines the vehicle speed based on the frequency of the pulse signal.- HINT:
- A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter. The signal is changed to pulse signal at the transistor in the combination meter. Each ECU controls the respective system based on the pulse signal.
- If a short occurs in any of the ECUs or in the wire harness connected to an ECU, all systems in the diagram below will not operate normally.
- A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter. The signal is changed to pulse signal at the transistor in the combination meter. Each ECU controls the respective system based on the pulse signal.


| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0500 |
While vehicle being driven, no vehicle speed sensor signal to ECM. (1 trip detection logic) |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.
| 1. CHECK HARNESS AND CONNECTOR (ECM - COMBINATION METER) |
Disconnect the ECM connector.

Disconnect the combination meter connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance (Check for open):
Tester Connection
Condition
Specified Condition
E1-36 (+S) - D32-8 (SPD)
Always
Below 1 Ω
Reconnect the ECM connector.
Reconnect the combination meter connector.
|
|
||||
| OK | |
| 2. INSPECT COMBINATION METER ASSEMBLY (OUTPUT WAVEFORM) |
Remove the combination meter.

Connect the oscilloscope to terminal E1-9(+S) and body ground.
Turn the ignition switch on (IG).
Turn the wheel slowly.
Check the signal waveform according to the condition(s) in the table below.
Item
Condition
Tool setting
5 V / DIV., 20 ms / DIV.
Vehicle condition
Driving at approx. 20 km/h (12 mph)
- OK:
- The waveform is displayed as shown in the illustration.
- HINT:
- When the system is functioning normally, one wheel revolution generates 4 pulses. As the vehicle speed increases, the width indicated by (A) in the illustration narrows.
|
|
||||
| OK | ||
| ||
| 3. CHECK HARNESS AND CONNECTOR (ECM - JUNCTION CONNECTOR) |
Disconnect the ECM connector.

Disconnect the junction connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance (Check for open):
Tester Connection
Condition
Specified Condition
D46-11 - D32-8 (SPD)
Always
Below 1 Ω
Reconnect the ECM connector.
Reconnect the junction connector.
|
|
||||
| OK | ||
| ||
