2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from May 2007


INSPECT ENTRY LOCK SWITCH (for Driver Side)

  1. B112465E32
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    for LHD:
    Tester Connection
    Condition
    Specified Condition
    z13-1 (TRG-) - z13-3 (TRG+)
    Lock switch not pushed
    10 kΩ or higher
    z13-1 (TRG-) - z13-3 (TRG+)
    Lock switch pushed
    Below 1 Ω
    for RHD:
    Tester Connection
    Condition
    Specified Condition
    z15-1 (TRG-) - z15-3 (TRG+)
    Lock switch not pushed
    10 kΩ or higher
    z15-1 (TRG-) - z15-3 (TRG+)
    Lock switch pushed
    Below 1 Ω

    If the result is not specified, replace the entry lock switch.


INSPECT ENTRY LOCK SWITCH (for Front Passenger Side)

  1. B112465E33
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    for LHD:
    Tester Connection
    Condition
    Specified Condition
    z15-1 (TRG-) - z15-3 (TRG+)
    Lock switch not pushed
    10 kΩ or higher
    z15-1 (TRG-) - z15-3 (TRG+)
    Lock switch pushed
    Below 1 Ω
    for RHD:
    Tester Connection
    Condition
    Specified Condition
    z13-1 (TRG-) - z13-3 (TRG+)
    Lock switch not pushed
    10 kΩ or higher
    z13-1 (TRG-) - z13-3 (TRG+)
    Lock switch pushed
    Below 1 Ω

    If the result is not specified, replace the entry lock switch.

← REMOVAL (from Jul 2010)INSTALLATION (May 2007 – Jul 2008) →