2007-2013 Highlander Kluger · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY

  1. A085603E04
    Apply adhesive to 2 or 3 threads of the oil pressure switch assembly.

    Adhesive:
    Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

  1. A127994
    Using a 24 mm deep socket wrench, install the oil pressure switch assembly. (w/o oil cooler)

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Do not start the engine for at least 1 hour after installation.

  1. A170011
    Using a 24 mm deep socket wrench, install the oil pressure switch assembly. (w/ oil cooler)

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Do not start the engine for at least 1 hour after installation.

  1. Connect the oil pressure switch assembly connector.

  1. A170012E01
    Connect the wiring harness protector. (w/ oil cooler)


2. INSPECT FOR OIL LEAK
  1. Start the engine.

  1. Check for engine oil leaks from the oil pressure switch assembly.


3. INSTALL FRONT FENDER APRON SEAL RH (for 4WD)

  1. A171853
    Install the front fender apron seal RH with the 2 bolts and clip.


4. INSTALL FRONT FENDER LINER RH (for 4WD)

5. INSTALL ENGINE UNDER COVER ASSEMBLY (for 2WD)

  1. A171850
    Install the engine under cover assembly with the 2 bolts, 2 screws and 5 clips.

  1. A171849
    Install the engine under cover assembly RR with the 2 bolts.


6. INSTALL FRONT WHEEL RH (for 4WD)

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }

← INSTALLATION (May 2007 – Jul 2008)INSTALLATION (from Jul 2010) →