2007-2013 Highlander Kluger · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from May 2007


INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY
  1. Disconnect the oil pressure switch assembly connector.

  1. Start the engine.

  1. A159695E02
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    B26-1 - Switch body
    Idling
    10 kΩ or higher
    B26-1 - Switch body
    Engine stopped
    Below 1 Ω

  1. Reconnect the oil pressure switch assembly connector.
    If the result is not as specified, replace the oil pressure switch assembly.

← REMOVAL (from Jul 2010)INSTALLATION (May 2007 – Jul 2008) →