2007-2013 Highlander Kluger · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. REMOVE FRONT WHEEL RH (for 4WD)

2. REMOVE ENGINE UNDER COVER ASSEMBLY (for 2WD)

  1. A171849
    Remove the 2 bolts and engine under cover assembly RR.

  1. A171850
    Remove the 2 bolts, 2 screws, 5 clips and engine under cover assembly.


3. DISCONNECT FRONT FENDER LINER RH (for 4WD)

4. REMOVE FRONT FENDER APRON SEAL RH (for 4WD)

  1. A171853
    Remove the 2 bolts, clip and front fender apron seal RH.


5. REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY

  1. A170012E01
    Disconnect the wiring harness protector. (w/ oil cooler)

  1. Disconnect the oil pressure switch assembly connector.

  1. A127994
    Using a 24 mm deep socket wrench, remove the oil pressure switch assembly. (w/o oil cooler)

  1. A170011
    Using a 24 mm deep socket wrench, remove the oil pressure switch assembly. (w/ oil cooler)

← REMOVAL (May 2007 – Jul 2008)REMOVAL (from Jul 2010) →