2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. INSTALL ELECTRICAL KEY OSCILLATOR

  1. B174733
    Connect the connector.

  1. Install the indoor electrical key oscillator with the clamp.


2. INSTALL CONSOLE BOX ASSEMBLY (w/o Rear Air Conditioning System)

  1. B173629
    Engage the 6 claws.

  1. B173628
    Install the console box assembly with the 4 bolts and 2 screws.


3. INSTALL CONSOLE BOX ASSEMBLY (w/ Rear Air Conditioning System)

  1. B175149
    Engage the 6 claws.

  1. Connect the connector.

  1. B181135
    Install the console box assembly with the 4 bolts and 2 screws.


4. INSTALL LOWER REAR CONSOLE BOX
  1. Install the lower rear console box.


5. INSTALL NO. 2 CONSOLE BOX DUCT (w/o Rear Air Conditioning System)

  1. B173013
    Install the No. 2 console box duct as shown in the illustration.


6. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY

  1. B168372
    Connect the connector.

  1. Engage the 4 claws and 4 clips, and install the upper console panel sub-assembly.


7. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

  1. B184681E01
    Apply protective tape to the areas shown in the illustration.

  1. Connect each connector.

  1. Engage the 10 claws and 8 clips, and install the center instrument cluster finish panel assembly.

    NOTICE:
    Do not the damage the instrument panel safety pad assembly and lower instrument panel finish panel sub-assembly.

← INSTALLATION (May 2007 – Jul 2008)INSTALLATION (from Jul 2010) →