2007-2013 Highlander Kluger · Service Manual BRAKE

INSTALLATION

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.
  3. The rear speed sensor is a component of the rear axle hub and bearing assembly. If the sensor malfunctions, replace the rear axle hub and bearing assembly.
  4. If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.


1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY
  1. Install the rear axle hub and bearing assembly (Click here).

    HINT:
    1. The rear speed sensor is a component of the rear axle hub and bearing assembly. If the sensor malfunctions, replace the rear axle hub and bearing assembly.
    2. If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.


2. INSPECT REAR AXLE HUB BEARING LOOSENESS

  1. C165994
    Using a dial indicator, check for looseness near the center of the axle hub.

    Maximum looseness:
    0 mm (0 in.)

    NOTICE:
    Ensure that the dial indicator is set perpendicular to the measurement surface.

    If the looseness exceeds the maximum, replace the rear axle hub and bearing assembly.


3. INSPECT REAR AXLE HUB RUNOUT

  1. C165995
    Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.

    Maximum runout:
    0.08 mm (0.0031 in.)

    NOTICE:
    Ensure that the dial indicator is set perpendicular to the measurement surface.

    If the runout exceeds the maximum, replace the rear axle hub and bearing assembly.


4. INSTALL REAR DISC

  1. C166438E01
    Align matchmarks and install the rear disc.

    NOTICE:
    When replacing the rear disc with a new one, select the installation position where the rear disc has minimal runout.


5. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

  1. C167785
    Install the rear disc brake caliper assembly with the 2 bolts.

    Torque:
    78 N*m{ 795 kgf*cm , 57 ft.*lbf }


6. INSTALL REAR SPEED SENSOR WIRE

  1. C167421
    Connect the connector to the rear speed sensor.


7. INSTALL REAR WHEEL

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }


8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


9. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
(Click here)

10. CHECK FOR REAR SPEED SENSOR SIGNAL
(Click here)
← INSTALLATION (Aug 2008 – Jun 2010)COMPONENTS (May 2007 – Jun 2010) →