INSTALLATION
Removal / installation · Vehicles built May 2007 – Jul 2008
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
- HINT:
- If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly with rear speed sensor.
| 1.
INSTALL REAR SPEED SENSOR |
 |
Clean the contact surface between the rear axle hub and bearing assembly and a new rear speed sensor.
- NOTICE:
- Prevent foreign matter from attaching to the sensor rotor.
- Place the rear speed sensor on the axle hub so that the connector is positioned as shown in the illustration.
- Using SST, a steel plates, V-blocks and press, install a new rear speed sensor to the rear axle hub and bearing assembly.
- SST
- 09214-76011
09213-58013
- NOTICE:
- Keep the rear speed sensor away from magnets.
- Do not use a hammer to install the rear speed sensor.
- Check that there is no foreign matter such as iron chips on the detecting portion of the rear speed sensor.
- Slowly press in the rear speed sensor straight.
| 2.
INSTALL REAR AXLE HUB AND BEARING ASSEMBLY WITH REAR SPEED SENSOR
|
 |
- Install the parking brake assembly and the rear axle hub and bearing assembly with the 4 bolts.
-
Torque:
- 75 N*m{
764 kgf*cm
, 55 ft.*lbf
}
- NOTICE:
- Do not twist the No. 3 parking brake cable assembly when installing it.
| 3.
INSPECT REAR AXLE HUB BEARING LOOSENESS
|
 |
- Using a dial indicator, check for looseness near the center of the axle hub.
- Maximum looseness:
- 0 mm (0 in.)
- NOTICE:
- Ensure that the dial indicator is set perpendicular to the measurement surface.
If the looseness exceeds the maximum, replace the rear axle hub and bearing assembly.
| 4.
INSPECT REAR AXLE HUB RUNOUT
|
 |
- Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.
- Maximum runout:
- 0.08 mm (0.0031 in.)
- NOTICE:
- Ensure that the dial indicator is set perpendicular to the measurement surface.
If the runout exceeds the maximum, replace the rear axle hub and bearing assembly.
| 5.
INSTALL REAR DISC
|
 |
- Align matchmarks and install the rear disc.
- NOTICE:
- When replacing the rear disc with a new one, select the installation position where the rear disc has minimal runout.
| 6.
INSTALL REAR DISC BRAKE CALIPER ASSEMBLY
|
 |
- Install the rear disc brake caliper assembly with the 2 bolts.
-
Torque:
- 78 N*m{
795 kgf*cm
, 57 ft.*lbf
}
| 7.
INSTALL REAR SPEED SENSOR WIRE |
 |
- Connect the connector to the rear speed sensor.
| 8.
INSTALL REAR WHEEL |
 |
-
Torque:
- 103 N*m{
1050 kgf*cm
, 76 ft.*lbf
}
| 9.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
 |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected. (Click here)
| 10.
INSPECT AND ADJUST REAR WHEEL ALIGNMENT |
 |
- HINT:
- (Click here).
| 11.
CHECK FOR REAR SPEED SENSOR SIGNAL |
 |
- HINT:
- (Click here).