2007-2013 Highlander Kluger · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built May 2007 – Jun 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010


1. REMOVE COOL AIR INTAKE DUCT SEAL

  1. B172745
    Remove the 11 clips and cool air intake duct seal.


2. REMOVE RADIATOR GRILLE

  1. B172749E01
    Put protective tape around the radiator grille.

  1. B172746
    Remove the 2 bolts and 4 clips.

  1. B172747
    Disengage the 6 claws and 4 guides, and remove the radiator grille.


3. REMOVE FRONT BUMPER ASSEMBLY (w/o Fog Light)

  1. B172760E01
    Put protective tape around the front bumper assembly.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. B172761E01
    Remove the screw.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. B172763
    Remove the 7 screws and clip.

  1. B172764
    Disengage the 4 claws and disconnect the front bumper assembly.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Remove the front bumper assembly.


4. REMOVE FRONT BUMPER ASSEMBLY (w/ Fog Light)

  1. B172760E01
    Put protective tape around the front bumper assembly.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. B172761E01
    Remove the screw.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. B172763
    Remove the 7 screws and clip.

  1. B172764
    Disengage the 4 claws and disconnect the front bumper assembly.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Disconnect each fog light connector, and then remove the front bumper assembly.

← COMPONENTS (from Jul 2010)REMOVAL (from Jul 2010) →