REMOVAL
Removal / installation · Vehicles built from Jul 2010
Versions by build date: May 2007 – Jun 2010 from Jul 2010
| 1.
REMOVE COOL AIR INTAKE DUCT SEAL
|
 |
- Remove the 11 clips and cool air intake duct seal.
| 2.
REMOVE RADIATOR GRILLE SUB-ASSEMBLY
|
 |
- Put protective tape around the radiator grille sub-assembly.
Text in Illustration
*1
|
Protective Tape
|
- Remove the 6 clips.
Disengage the 8 claws and 2 guides, and remove the radiator grille sub-assembly.
| 3.
REMOVE FRONT BUMPER ASSEMBLY |
 |
- Put protective tape around the front bumper assembly.
Text in Illustration
*1
|
Protective Tape
|
- Remove the screw.
- HINT:
- Use the same procedure for the RH side and LH side.
Using a screwdriver, turn the pin 90 degrees and remove the 2 pin hold clips.
- HINT:
- Use the same procedure for the RH side and LH side.
- Remove the 8 screws and 3 clips.
- Disengage the 5 claws and disconnect the front bumper assembly.
- HINT:
- Use the same procedure for the RH side and LH side.
Disconnect each fog light connector, and then remove the front bumper assembly.