REASSEMBLY
Removal / installation · Vehicles built from Jul 2010
Versions by build date: May 2007 – Jun 2010 from Jul 2010
| 1.
INSTALL FRONT BUMPER STAY LH |
 |
- Engage the 2 claws and install the front bumper stay LH.
Install the bolt and screw.
-
Torque:
- Bolt:
- 3.6 N*m{
37 kgf*cm
, 32 in.*lbf
}
- Screw:
- 3.0 N*m{
31 kgf*cm
, 27 in.*lbf
}
| 2.
INSTALL FRONT BUMPER STAY RH |
 |
- HINT:
- Use the same procedure as for the LH side.
| 3.
INSTALL FRONT BUMPER REINFORCEMENT |
 |
- Install the front bumper reinforcement with the 6 bolts.
-
Torque:
- 64 N*m{
653 kgf*cm
, 47 ft.*lbf
}
| 4.
INSTALL FRONT BUMPER ENERGY ABSORBER |
 |
- Engage the 2 guides and install the front bumper energy absorber.
| 5.
INSTALL FRONT BUMPER MOULDING |
 |
- Engage the 4 claws to install the front bumper moulding.
Install the 3 screws.
| 6.
INSTALL LOWER RADIATOR GRILLE SUB-ASSEMBLY |
 |
- Engage the 18 claws to install the lower radiator grille sub-assembly.
| 7.
INSTALL FRONT BUMPER HOLE COVER LH |
 |
- Engage the 2 claws and install the front bumper hole cover LH.
| 8.
INSTALL FRONT BUMPER HOLE COVER RH |
 |
- HINT:
- Use the same procedure as for the LH side.
| 9.
INSTALL FOG LIGHT ASSEMBLY LH (w/ Fog Light)
|
 |
- Engage the 3 claws and pin to install the fog light assembly.
| 10.
INSTALL FOG LIGHT ASSEMBLY RH (w/ Fog Light) |
 |
- HINT:
- Use the same procedure as for the LH side.
| 11.
INSTALL FOG LIGHT COVER LH |
 |
- Engage the 7 claws and guide to install the fog light cover LH.
- Engage the claw to install the outside moulding retainer.
| 12.
INSTALL FOG LIGHT COVER RH |
 |
- HINT:
- Use the same procedure as for the LH side.
| 13.
INSTALL FRONT FENDER LINER RETAINER |
 |
- Engage the 2 claws to install the 2 front fender liner retainers.
- HINT:
- Use the same procedure for the RH side and LH side.