2007-2013 Highlander Kluger · Service Manual BODY

REASSEMBLY

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010


1. INSTALL NO. 1 REAR BUMPER SIDE SUPPORT

  1. B172731
    Engage the 2 claws and install a new No. 1 rear bumper side support.

    HINT:
    Use the same procedure for the RH side and LH side.


2. INSTALL NO. 2 REAR BUMPER SIDE SUPPORT LH

  1. B172730
    Engage the 3 claws and install a new No. 2 rear bumper side support LH.

  1. Install the 2 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }


3. INSTALL NO. 2 REAR BUMPER SIDE SUPPORT RH

HINT:
Use the same procedure as for the LH side.


4. INSTALL REAR BUMPER SIDE RETAINER LH

  1. B172729
    Engage the 2 claws and install a new rear bumper side retainer LH.

  1. Install the screw.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }


5. INSTALL REAR BUMPER SIDE RETAINER RH

HINT:
Use the same procedure as for the LH side.


6. INSTALL REAR BUMPER REINFORCEMENT

  1. B260036
    Install the rear bumper reinforcement with the 6 nuts.

    Torque:
    64 N*m{ 653 kgf*cm , 47 ft.*lbf }


7. INSTALL REAR BUMPER ENERGY ABSORBER

  1. B260026
    Engage the 2 guides and install the rear bumper energy absorber.


8. INSTALL REAR BUMPER MOULDING

  1. B256722
    Engage the 7 claws to install the rear bumper moulding.

  1. B256724
    Engage the 2 claws to install the 2 outside moulding retainers.


9. INSTALL LOWER REAR BUMPER COVER

  1. B256717
    Engage the 8 claws to install the lower rear bumper cover.

  1. B256719
    Engage the 2 claws to install the 2 outside moulding retainers.


10. INSTALL REFLEX REFLECTOR ASSEMBLY LH

  1. B256721
    Engage the 2 claws and 2 guides to install the reflex reflector assembly LH.

  1. B256720
    Install the screw.


11. INSTALL REFLEX REFLECTOR ASSEMBLY RH

HINT:
Use the same procedure for the RH side and LH side.


12. INSTALL REAR FOG LIGHT ASSEMBLY (w/ Rear Fog Light)

  1. E155682
    Install the rear fog light assembly.


13. INSTALL REAR FOG LIGHT BRACKET (w/ Rear Fog Light)
  1. Engage the 4 claws and install the rear fog light bracket.

  1. Engage the clamp.

  1. E150608
    Tighten the 2 screws.

← REASSEMBLY (May 2007 – Jun 2010)INSTALLATION (May 2007 – Jun 2010) →