2007-2013 Highlander Kluger · Service Manual BODY

REASSEMBLY

Removal / installation · Vehicles built May 2007 – Jun 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010


1. INSTALL NO. 1 REAR BUMPER SIDE SUPPORT

  1. B172731
    Engage the 2 claws and install a new No. 1 rear bumper side support.

    HINT:
    Use the same procedure for the RH side and LH side.


2. INSTALL NO. 2 REAR BUMPER SIDE SUPPORT LH

  1. B172730
    Engage the 3 claws and install a new No. 2 rear bumper side support LH.

  1. Install the 2 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }


3. INSTALL NO. 2 REAR BUMPER SIDE SUPPORT RH

HINT:
Use the same procedures for the RH side and LH side.


4. INSTALL REAR BUMPER SIDE RETAINER LH

  1. B172729
    Engage the 2 claws and install a new rear bumper side retainer LH.

  1. Install the screw.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }


5. INSTALL REAR BUMPER SIDE RETAINER RH

HINT:
Use the same procedures for the RH side and LH side.


6. INSTALL REAR BUMPER REINFORCEMENT

  1. B172728
    Install the rear bumper reinforcement with the 6 nuts.

    Torque:
    64 N*m{ 653 kgf*cm , 47 ft.*lbf }


7. INSTALL REAR BUMPER PLATE LH

  1. B172727
    Engage the 3 claws and install the rear bumper plate LH.


8. INSTALL REAR BUMPER PLATE RH

HINT:
Use the same procedure for the RH side and LH side.


9. INSTALL REAR BUMPER BAR

  1. B172726
    Install the rear bumper bar on the rear bumper energy absorber.


10. INSTALL REAR BUMPER ENERGY ABSORBER

  1. B172725
    Engage the 2 guides, and install the rear bumper energy absorber.


11. INSTALL LOWER REAR BUMPER COVER
  1. Engage the 10 claws and install the lower rear bumper cover.

  1. Install the 2 clips.

    B172724


12. INSTALL REFLEX REFLECTOR ASSEMBLY LH

  1. B172723
    Install the reflex reflector assembly LH with the nut.


13. INSTALL REFLEX REFLECTOR ASSEMBLY RH

HINT:
Use the same procedure for the RH side and LH side.


14. INSTALL REAR FOG LIGHT ASSEMBLY (w/ Rear Fog Light)

  1. E155682
    Install the rear fog light assembly.


15. INSTALL REAR FOG LIGHT BRACKET (w/ Rear Fog Light)

  1. E150828
    Engage the 4 claws and install the rear fog light bracket.

  1. E150062
    Engage the clamp.

  1. E150608
    Tighten the 2 screws.

← DISASSEMBLY (from Jul 2010)REASSEMBLY (from Jul 2010) →