2007-2013 Highlander Kluger · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built May 2007 – Jun 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010


1. REMOVE COOL AIR INTAKE DUCT SEAL

  1. B172745
    Remove the 11 clips and cool air intake duct seal.


2. REMOVE RADIATOR GRILLE

  1. B172749E01
    Put protective tape around the radiator grille.

  1. B172746
    Remove the 2 bolts and 4 clips.

  1. B172747
    Disengage the 6 claws and 4 guides, and remove the radiator grille.


3. REMOVE RADIATOR GRILLE EMBLEM

  1. B172750
    Disengage the 3 claws and remove the radiator grille emblem.


4. REMOVE INSIDE RADIATOR GRILLE (w/ Plated Moulding)

  1. B172752
    Remove the 7 screws.

  1. B172753
    Disengage the 9 claws and remove the inside radiator grille.


5. REMOVE UPPER RADIATOR GRILLE MOULDING LH (w/ Plated Moulding)

  1. B172754
    Disengage the 4 claws and remove the upper radiator grille moulding LH.


6. REMOVE UPPER RADIATOR GRILLE MOULDING RH (w/ Plated Moulding)

HINT:
Use the same procedure for the RH side and LH side.


7. REMOVE CENTER RADIATOR GRILLE MOULDING LH (w/ Plated Moulding)

  1. B172755
    Disengage the 4 claws and remove the center radiator grille moulding LH.


8. REMOVE CENTER RADIATOR GRILLE MOULDING RH (w/ Plated Moulding)

HINT:
Use the same procedure for the RH side and LH side.


9. REMOVE LOWER RADIATOR GRILLE MOULDING LH (w/ Plated Moulding)

  1. B172756
    Disengage the 4 claws and remove the lower radiator grille moulding LH.


10. REMOVE LOWER RADIATOR GRILLE MOULDING RH (w/ Plated Moulding)

HINT:
Use the same procedure for the RH side and LH side.

← COMPONENTS (from Jul 2010)REMOVAL (from Jul 2010) →