2007-2013 Highlander Kluger · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built May 2007 – Jun 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010


1. REMOVE REAR QUARTER PANEL MUDGUARD LH (w/ Rear Fender Mudguard)

  1. B172720E01
    Remove the screw (A).

  1. Using a 4 mm hexagon wrench, remove the 6 screws (B).


2. REMOVE REAR QUARTER PANEL MUDGUARD RH (w/ Rear Fender Mudguard)

HINT:
Use the same procedures for the RH side and LH side.


3. REMOVE REAR WHEEL HOUSE PAD LH

  1. B174755
    Remove the 3 screws and rear wheel house pad LH.


4. REMOVE REAR WHEEL HOUSE PAD RH

HINT:
Use the same procedure for the RH side and LH side.


5. REMOVE QUARTER PANEL SEAL LH

  1. B174756E01
    Remove the 4 screws.

  1. Peel off the double-sided tape and remove the quarter panel seal LH.


6. REMOVE QUARTER PANEL SEAL RH

HINT:
Use the same procedures for the RH side and LH side.


7. REMOVE REAR BUMPER SIDE SEAL LH

  1. B174757
    Remove the clip, screw and bolt.

  1. Remove the 2 grommets.

    HINT:
    The grommets need to be replaced with new ones because they will break when they are removed.

  1. Remove the rear bumper side seal LH.


8. REMOVE REAR BUMPER SIDE SEAL RH

HINT:
Use the same procedures for the RH side and LH side.


9. REMOVE REAR WHEEL HOUSE LINER LH

  1. B174758
    Remove the 10 clips and rear wheel house liner LH.


10. REMOVE REAR WHEEL HOUSE LINER RH

  1. B174759
    Remove the 10 clips and rear wheel house liner RH.

← COMPONENTS (from Jul 2010)REMOVAL (from Jul 2010) →