2007-2013 Highlander Kluger · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010


1. REMOVE REAR QUARTER PANEL MUDGUARD LH

  1. B261562E01
    Remove the 2 screws (A).

  1. Using a 4 mm hexagon wrench, remove the 3 screws (B).


2. REMOVE REAR QUARTER PANEL MUDGUARD RH

HINT:
Use the same procedure as for the LH side.


3. REMOVE REAR WHEEL HOUSE PAD LH

  1. B174755
    Remove the 3 screws and rear wheel house pad LH.


4. REMOVE REAR WHEEL HOUSE PAD RH

HINT:
Use the same procedure as for the LH side.


5. REMOVE QUARTER PANEL SEAL LH

  1. B174756E01
    Remove the 4 screws.

  1. Peel off the double-sided tape and remove the quarter panel seal LH.


6. REMOVE QUARTER PANEL SEAL RH

HINT:
Use the same procedure as for the LH side.


7. REMOVE REAR BUMPER SIDE SEAL LH

  1. B174757
    Remove the clip, screw and bolt.

  1. Remove the 2 grommets.

    HINT:
    The grommets need to be replaced with new ones because they will break when they are removed.

  1. Remove the rear bumper side seal LH.


8. REMOVE REAR BUMPER SIDE SEAL RH

HINT:
Use the same procedure as for the LH side.


9. REMOVE REAR WHEEL HOUSE LINER LH

  1. B174758
    Remove the 10 clips and rear wheel house liner LH.


10. REMOVE REAR WHEEL HOUSE LINER RH

  1. B174759
    Remove the 10 clips and rear wheel house liner RH.

← REMOVAL (May 2007 – Jun 2010)INSTALLATION (May 2007 – Jun 2010) →