2007-2013 Highlander Kluger · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built from May 2007


1. REMOVE ROOF DRIP SIDE FINISH MOULDING JOINT COVER (w/o Roof Rack)

  1. B174410E01
    Disengage the clip and claw, and remove the roof drip side finish moulding joint cover as shown in the illustration.

    HINT:
    Use the same procedure for the rear side and front side.


2. REMOVE FRONT ROOF RACK LEG COVER (w/ Roof Rack)

  1. B172784E01
    Put protective tape around the front roof rack leg cover.

  1. Using a moulding remover, disengage the 4 claws.

    NOTICE:
    Be careful not to damage the claws.

  1. Disengage the guide and remove the front roof rack leg cover.

    B172785


3. REMOVE REAR ROOF RACK LEG COVER (w/ Roof Rack)

  1. B172787E01
    Put protective tape around the rear roof rack leg cover.

  1. Using a moulding remover, disengage the 4 claws.

    NOTICE:
    Be careful not to damage the claws.

  1. Disengage the guide and remove the rear roof rack leg cover.

    B172788


4. REMOVE ROOF RACK ASSEMBLY (w/ Roof Rack)

  1. Remove the 4 bolts and roof rack assembly.

    B172790

  1. B174760E01
    Remove the 4 gaskets.


5. REMOVE CENTER ROOF DRIP SIDE FINISH MOULDING

  1. B172781E01
    Place a matchmark on the vehicle body on the location indicated in the illustration.

  1. Remove the center roof drip side finish moulding.


6. REMOVE ROOF DRIP SIDE FINISH MOULDING (for Front Side)

  1. B172779
    Disengage the clip and remove the roof drip side finish moulding.


7. REMOVE ROOF DRIP SIDE FINISH MOULDING (for Rear Side)

  1. B172782
    Disengage the clip and remove the roof drip side finish moulding.


8. REMOVE CENTER ROOF RACK BRACKET (w/o Roof Rack)

  1. B175708
    Remove the 2 bolts and center roof rack bracket.

    HINT:
    Use the same procedure for the rear side and front side.

← COMPONENTS (from May 2007)INSTALLATION (from May 2007) →