2007-2013 Highlander Kluger · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built May 2007 – Jun 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010

HINT:
When removing the side mudguard, heat the vehicle body and side mudguard using a heat light.

Heating temperature:
Item
Temperature
Vehicle Body
40 to 60°C (104 to 140°F)
Side Mudguard
20 to 30°C (68 to 86°F)

NOTICE:
Do not heat the vehicle body or side mudguard excessively.


1. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY

  1. B172795
    Remove the clip.

  1. Using a 4 mm hexagon wrench, remove the screw.

  1. B172796
    Peel off the front fender side protector and disengage the 3 clips, and then remove the front fender moulding sub-assembly.

  1. Remove the pad from the front fender moulding sub-assembly.

  1. Remove the 2 No. 4 clips from the front fender moulding sub-assembly.

  1. B172797E01
    Remove the front fender side protector from the front fender moulding sub-assembly.


2. REMOVE FRONT FENDER OUTSIDE MOULDING PAD

  1. B172798E01
    Remove the front fender outside moulding pad from the front fender moulding sub-assembly.


3. REMOVE FRONT DOOR OUTSIDE MOULDING SUB-ASSEMBLY

  1. B172799
    Turn back the front door weatherstrip.

  1. Remove the nut.

  1. B172800E01
    Peel off the upper front door outside moulding pad and disengage the 11 clips, and then remove the front door outside moulding sub-assembly.

  1. Remove the gasket from the front door outside moulding sub-assembly.

  1. Remove the 3 No. 3 clips pad from the front door outside moulding sub-assembly.

  1. Remove the 8 No. 4 clips pad from the front door outside moulding sub-assembly.

  1. B172801E01
    Remove the upper front door outside moulding pad from the front door outside moulding sub-assembly.


4. REMOVE REAR DOOR OUTSIDE MOULDING SUB-ASSEMBLY

  1. B172802
    Turn back the rear door No. 2 weatherstrip.

  1. Remove the nut.

  1. B172803E01
    Peel off the upper rear door outside moulding pad and disengage the 8 clips, and then remove the rear door outside moulding sub-assembly.

  1. Remove the gasket from the rear door outside moulding sub-assembly.

  1. Remove the 2 No. 3 clips pad from the rear door outside moulding sub-assembly.

  1. Remove the 6 No. 4 clips pad from the rear door outside moulding sub-assembly.

  1. B172804E01
    Remove the upper rear door outside moulding pad from the rear door outside moulding sub-assembly.

← COMPONENTS (from Jul 2010)REMOVAL (from Jul 2010) →