2007-2013 Highlander Kluger · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010

HINT:
When removing the side mudguards, heat the vehicle body and side mudguards using a heat light.

Heating temperature:
Item
Temperature
Vehicle Body
40 to 60°C (104 to 140°F)
Side Mudguard
20 to 30°C (68 to 86°F)

NOTICE:
Do not heat the vehicle body or side mudguards excessively.


1. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY

  1. B172795
    Remove the clip.

  1. Using a 4 mm hexagon wrench, remove the screw.

  1. B172796
    Peel off the double-sided tape and disengage the 3 clips, and then remove the front fender moulding sub-assembly.

  1. Remove the pad from the front fender moulding sub-assembly.

  1. Remove the 2 No. 4 clips from the front fender moulding sub-assembly.

  1. B172797E02
    Remove the double-sided tape from the front fender moulding sub-assembly.
    Text in Illustration 
    *1
    Double-sided Tape


2. REMOVE FRONT FENDER OUTSIDE MOULDING PAD

  1. B260020E01
    Remove the front fender outside moulding pad from the front fender moulding sub-assembly.
    Text in Illustration 
    *1
    Front Fender Outside Moulding Pad


3. REMOVE FRONT DOOR OUTSIDE MOULDING SUB-ASSEMBLY

  1. B172799
    Turn back the front door weatherstrip.

  1. Remove the nut.

  1. B260021E01
    Peel off the double-sided tape and disengage the 11 clips, and then remove the front door outside moulding sub-assembly.
    Text in Illustration 
    *1
    No. 4 Clip
    *2
    No. 3 Clip

  1. Remove the gasket from the front door outside moulding sub-assembly.

  1. Remove the 3 No. 3 clips from the front door outside moulding sub-assembly.

  1. Remove the 8 No. 4 clips from the front door outside moulding sub-assembly.

  1. B258291E01
    Remove the double-sided tape from the front door outside moulding sub-assembly.
    Text in Illustration 
    *1
    Double-sided Tape


4. REMOVE REAR DOOR OUTSIDE MOULDING SUB-ASSEMBLY

  1. B172802
    Turn back the rear door No. 2 weatherstrip.

  1. Remove the nut.

  1. B260024E01
    Peel off the double-sided tape and disengage the 8 clips, and then remove the rear door outside moulding sub-assembly.
    Text in Illustration 
    *1
    No. 4 Clip
    *2
    No. 3 Clip

  1. Remove the gasket from the rear door outside moulding sub-assembly.

  1. Remove the 2 No. 3 clips from the rear door outside moulding sub-assembly.

  1. Remove the 6 No. 4 clips from the rear door outside moulding sub-assembly.

  1. B258292E01
    Remove the double-sided tape from the rear door outside moulding sub-assembly.
    Text in Illustration 
    *1
    Double-sided Tape

← REMOVAL (May 2007 – Jun 2010)INSTALLATION (May 2007 – Jun 2010) →