2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built from May 2007


1. INSTALL REAR WIPER RUBBER

  1. E144307E03
    Install the rear wiper rubber backing plates as shown in the illustration.

    NOTICE:
    Install the backing plates facing the correct direction.

  1. Insert the wiper rubber from the front end of the wiper blade to the rear end through the second claw.

  1. B117902E03
    After pushing the wiper rubber through the rear end claw, allow it to stick out from the rear end stopper.

  1. B117903E01
    Slide the wiper rubber through the front end claw.


2. INSTALL REAR WIPER BLADE ASSEMBLY

  1. E150199
    Push the wiper blade straight toward the right side of the vehicle to install it to the wiper arm.

    NOTICE:
    Be careful not to damage the claw.

  1. E150155
    Connect the rear wiper head cap.

← REMOVAL (from May 2007)COMPONENTS (from May 2007) →