2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built from May 2007


1. REMOVE REAR WIPER BLADE ASSEMBLY

  1. E151102
    Disconnect the rear wiper arm head cap.

  1. E150201
    Raise the wiper blade to the position where the claw detaches with a ''click'' sound, as shown in the illustration.

    NOTICE:
    Be careful not to damage the claw.

  1. E150200
    Pull the wiper blade straight toward the left side of the vehicle to remove it from the wiper arm.

    NOTICE:
    Do not lower the wiper arm with the wiper blade removed. The arm tip may damage the back door glass surface.


2. REMOVE REAR WIPER RUBBER

  1. B117843E03
    Lift and pull the end of the wiper rubber protruding from the blade stopper as shown in the illustration.

    NOTICE:
    Do not forcibly pull out the wiper rubber. The backing plates will be deformed or the blade claws will be damaged.

    HINT:
    Lightly pushing the rubber between the ends and middle will allow it to be removed more easily.

← COMPONENTS (from May 2007)INSTALLATION (from May 2007) →