2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. REMOVE COOL AIR INTAKE DUCT SEAL

  1. B258270
    Remove the 11 clips and cool air intake duct seal.


2. REMOVE RADIATOR GRILLE SUB-ASSEMBLY

  1. B258273E01
    Put protective tape around the radiator grille sub-assembly.
    Text in Illustration 
    *1
    Protective Tape

  1. B258271
    Remove the 6 clips.

  1. Disengage the 8 claws and 2 guides, and remove the radiator grille sub-assembly.


3. REMOVE FRONT BUMPER ASSEMBLY

  1. B258274E01
    Put protective tape around the front bumper assembly.
    Text in Illustration 
    *1
    Protective Tape

  1. B258275E01
    Remove the screw.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Using a screwdriver, turn the pin 90 degrees and remove the 2 pin hold clips.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. B258277
    Remove the 8 screws and 3 clips.

  1. B258278
    Disengage the 5 claws and disconnect the front bumper assembly.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Disconnect each fog light connector, and then remove the front bumper assembly.


4. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.


5. REMOVE FRONT FENDER LINER RH

  1. B258290E01
    Remove the screw.

  1. Using a screwdriver, turn the pin 90 degrees and remove the 2 pin hold clips.

  1. B260030
    Using a 4 mm hexagon wrench, remove the 2 screws.

  1. Remove the 3 grommets.

    HINT:
    The grommets need to be replaced with new ones because they will break when they are removed.

  1. B260028
    Remove the 5 clips

  1. Remove the bolt, 8 screws and front fender liner RH.


6. DRAIN WASHER FLUID

  1. E150185
    Disconnect the washer hose from the rear washer motor and pump assembly, and drain the washer fluid.


7. REMOVE REAR WASHER MOTOR AND PUMP ASSEMBLY

  1. E150197E01
    Disconnect the connector.

  1. Remove the rear washer motor and pump assembly.

← REMOVAL (Aug 2008 – Jun 2010)INSPECTION (from May 2007) →