2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

ADJUSTMENT

Removal / installation · Vehicles built from May 2007


1. REMOVE WASHER NOZZLE SUB-ASSEMBLY

  1. E147127E01
    Using a screwdriver, disengage the 2 claws and separate the washer nozzle sub-assembly as shown in the illustration.

    NOTICE:
    Be careful not to damage the windshield.

    HINT:
    Tape the screwdriver tip before use.

  1. E128831
    Remove the washer nozzle sub-assembly from the washer hose.

    NOTICE:
    Washer nozzles cannot be reused.


2. ADJUST WASHER NOZZLE SUB-ASSEMBLY

  1. Select a washer nozzle sub-assembly so that the washer fluid spray area is as specitied.

    E150188E01


3. INSTALL WASHER NOZZLE SUB-ASSEMBLY

  1. E128831
    Connect a new washer nozzle sub-assembly to the washer hose.

  1. B163611E01
    Engage the 2 claws and install the washer nozzle sub-assembly as shown in the illustration.

← REMOVAL (from May 2007)INSTALLATION (from May 2007) →