2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

ON-VEHICLE INSPECTION

Inspection · Vehicles built from May 2007


INSPECT FRONT WASHER NOZZLE SUB-ASSEMBLY

  1. With the engine running, check the positions that the washer fluid hits the windshield.

    E150189E01

    Area
    Dimension
    A
    353 mm (13.88 in.)
    B
    143 mm (5.70 in.)
    C
    193 mm (7.61 in.)

    OK:
    Washer fluid hits the windshield in the areas shown in the illustration.

    HINT:
    If the result is not as specified, replace the washer nozzle.


INSPECT REAR WASHER NOZZLE SUB-ASSEMBLY

  1. With the engine running, check the position that the washer fluid hits the windshield.

    E150191E01

    Area
    Dimension
    Area
    Dimension
    A
    265 mm (10.44 in.)
    E
    252 mm (9.92 in.)
    B
    197 mm (7.77 in.)
    F
    178 mm (7.00 in.)
    C
    0.4 mm (0.01 in.)
    G
    25 mm (0.98 in.)
    D
    109 mm (4.27 in.)
    H
    139 mm (5.46 in.)

    OK:
    Washer fluid hits the windshield in the areas shown in the illustration.

← COMPONENTS (from May 2007)REMOVAL (from May 2007) →