2007-2013 Highlander Kluger · Service Manual SECURITIES

INSTALLATION

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. INSTALL HOOD LOCK ASSEMBLY

  1. B174198
    Apply MP grease to the sliding areas of the lock.

  1. B174194
    Connect the hood lock control cable.

  1. B174193
    Install the hood lock assembly with the 3 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. B174192
    Install the hood lock nut cap.

  1. B174191
    Connect the connector.


2. INSPECT HOOD SUB-ASSEMBLY

  1. Check that the clearance measurements of areas A through D are within each standard range.

    B257316E03

    Standard clearance:
    Area
    Measurement
    Area
    Measurement
    A
    4.5 to 8.5 mm (0.1777 to 0.335 in.)
    C
    2.5 to 5.5 mm (0.098 to 0.217 in.)
    B
    4.5 to 8.5 mm (0.1777 to 0.335 in.)
    D
    -1.5 to 1.5 mm (-0.059 to 0.059 in.)


3. ADJUST HOOD SUB-ASSEMBLY

  1. Horizontally and vertically adjust the hood.

    1. B172912
      Loosen the 4 hinge bolts of the hood.

    2. Adjust the clearance between the hood and front fender by moving the hood.

    3. Tighten the 4 hinge bolts after the adjustment.

      Torque:
      13 N*m{ 133 kgf*cm , 10 ft.*lbf }

  1. Adjust the height of the front end of the hood using the cushion rubber.

    1. B172913
      Adjust the cushion rubbers so that the heights of the hood and fender are aligned.

      HINT:
      Raise or lower the front end of the hood by turning the cushion rubber.

  1. Adjust the hood lock.

    1. B174192
      Remove the hood lock nut cap.

    2. B172915
      Loosen the 3 bolts.

    3. Tighten the bolts after the adjustment.

      Torque:
      8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

    4. B174192
      Install the hood lock nut cap.

    5. Check that the striker can engage with the hood lock smoothly.


4. INSTALL RADIATOR GRILLE SUB-ASSEMBLY

  1. B258272
    Engage the 2 guides and 8 claws, and install the radiator grille sub-assembly.

  1. Install the 6 clips.


5. INSTALL COOL AIR INTAKE DUCT SEAL
  1. Install the cool air intake duct seal with the 11 clips.

← INSTALLATION (Aug 2008 – Jun 2010)COMPONENTS (from May 2007) →