INSTALLATION
Removal / installation · Vehicles built May 2007 – Jul 2008
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
| 1.
INSTALL HOOD LOCK ASSEMBLY
|
 |
- Apply MP grease to the sliding areas of the lock.
- Connect the hood lock control cable.
- Install the hood lock assembly with the 3 bolts.
-
Torque:
- 8.0 N*m{
82 kgf*cm
, 71 in.*lbf
}
- Install the hood lock nut cap.
- Connect the connector.
| 2.
INSPECT HOOD SUB-ASSEMBLY
|
 |
Check that the clearance measurements of areas A through D are within each standard range.


- Standard clearance:
Area
|
Measurement
|
Area
|
Measurement
|
A
|
6.2 to 10.2 mm (0.244 to 0.402 in.)
|
C
|
2.5 to 5.5 mm (0.098 to 0.217 in.)
|
B
|
5.9 to 9.9 mm (0.232 to 0.390 in.)
|
D
|
-1.5 to 1.5 mm (-0.059 to 0.059 in.)
|
| 3.
ADJUST HOOD SUB-ASSEMBLY
|
 |
Horizontally and vertically adjust the hood.
- Loosen the 4 hinge bolts of the hood.
Adjust the clearance between the hood and front fender by moving the hood.
Tighten the 4 hinge bolts after the adjustment.
-
Torque:
- 13 N*m{
133 kgf*cm
, 10 ft.*lbf
}
Adjust the height of the front end of the hood using the cushion rubber.
- Adjust the cushion rubbers so that the heights of the hood and fender are aligned.
- HINT:
- Raise or lower the front end of the hood by turning the cushion rubber.
Adjust the hood lock.
- Remove the hood lock nut cap.
- Loosen the 3 bolts.
Tighten the bolts after the adjustment.
-
Torque:
- 8.0 N*m{
82 kgf*cm
, 71 in.*lbf
}
- Install the hood lock nut cap.
Check that the striker can engage with the hood lock smoothly.
| 4.
INSTALL RADIATOR GRILLE
|
 |
- Engage the 4 guides and 6 claws, and install the radiator grille.
- Install the 4 clips and 2 bolts.
| 5.
INSTALL COOL AIR INTAKE DUCT SEAL
|
 |
- Install the cool air intake duct seal with the 11 clips.