2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built May 2007 – Jun 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010


1. REMOVE REAR BUMPER ASSEMBLY

  1. B172737E01
    Put protective tape around the rear bumper assembly.

  1. B172735
    Remove the 5 clips, 8 screws and 2 bolts.

  1. B172736
    Disengage the 8 claws and disconnect the rear bumper assembly.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Disconnect the rear fog light connector, and then remove the rear bumper assembly.


2. REMOVE REAR FOG LIGHT BRACKET

  1. E150934
    Loosen the 2 screws as shown in the illustration.

  1. E150062
    Disengage the clamp.

  1. E150828
    Disengage the 4 claws and remove the rear fog light bracket.


3. REMOVE REAR FOG LIGHT ASSEMBLY

  1. E150063
    Remove the rear fog light assembly.

← COMPONENTS (from Jul 2010)REMOVAL (from Jul 2010) →